ROTATIONALLY
MOLDED I – RM 250/350 Dust Collector
Key Advantages
-
Lightweight
construction — no roof support reinforcement or structural supports
required. The resulting savings may pay for the unit.
-
No painting required.
-
Completely prewired —
saves installation and wiring time and expense. Included in warranty
package.
-
Easy filter access —
saves cleaning and replacement time and hassle.
-
Dimensionally compact units — easiest
filtration model to fit into limited space.
Design Features
-
Low density
rotationally molded polyethylene body is rated for service from -20 to
250 degrees F.
-
Corrosion resistant
polyethylene bin vent features 3/8" wall thickness with flanged body
sections and is designed for up to 1,500 CFM at 4:1 air to cloth ratio.
-
Lightweight
components, completely assembled —industry standard powder coated metal
or stainless steel.
-
Nine 6-inch diameter,
top loading pleated filters. 250 or 350 square feet of filter area (1
meter or 1.5 meter length).
-
Three valves with row
pulse cleaning and solid state on-demand timer.
-
Single row pulsing
limits backflow of air during cleaning.
-
Compact construction
— easy to handle.
-
Snap band top load filters for easy access and minimal
maintenance.
Technical Specs
-
Spool piece for 1.5
meter filter and 1,800 CFM capacity.
-
Control panel with
fan starter and disconnect, all pre-wired in Nema 4 or 4x enclosure.
Available with and without VFD on fan.
-
Stainless steel trim.
-
Hopper is molded with
65° angle.
-
Grounded
unit. Low-static feature available.
-
Custom fitting of
fans, hoppers and unload accessories.
-
Bin vent or complete
dust collection unit available.
-
Structurally designed for seismic zone 4 with 3' to 5'
clearance standard.
For more information contact:
HarmonDistributing@Eco-Blast.Com
18067 SW
Lower Boones Ferry Road
Tigard,
OR 97224-7719
Office/Voice Mail:
503-653-5571
Office/Fax:
503-922-1278
Toll Free:
877-735-7943
www.Eco-Blast.Com
HarmonDistributing@Eco-Blast.Com
